Hudson Reed UK Opiniões 

We purchased a shower tray from Hudson Reed after the one we previously had installed snapped in the middle and began to dip. We were so overwhelmed with the quality of the Hudson Reed shower tray we since went on to kit out 2 further bathrooms entirely in their products. Excellent quality, excellent delivery and economical pricing. Would recommend them to anyone looking for bathroom products that won't need replacing!

Avoid this company and its products at all costs. The quality of the items they sell is extremely lacking. We are a small developer and decided to install their bathroom taps and showers into 7 houses we have recently built. I have regretted that decision ever since we made it. Five of the taps have failed and the onwards customer support from Hudson Reed has been atrocious. They have ducked and dived to try and avoid accepting responsibility for the faulty taps, and this is for taps that weren't even cheap. They just repackage cheap chinese knock offs and take no responsibility for failures or warranty claims if anything goes wrong with the product even a couple of months down the line. AVOID AVOID AVOID

Don't buy Hudson Reed taps! I have just had a tap fitted in my bathroom which had been left over from a property refurbishment I did a year ago. The tap was still in the box and hadn't been used or fitted or even taken out of the box. My existing tap had been dripping for a while so I decided to replace it with the Hudson Reed tap which then dripped worse than the one I'd replaced. I was told that they weren't prepared to do anything about it even though it was obvious the tap was faulty and was advised to buy a new washer. I wrote to their technical department who eventually wrote back very rudely by somebody called Deborah telling me the number of the washer and that it would cost a further £32???
They are a shocking company, with a shocking customer service attitude and I wouldn't recommend them to my worst enemy.

Hudson Reed taps are not fit for purpose. To anybody who may be thinking of buying one of their bathroom taps, please note that you are permitted to clean said taps only with hot water and a cloth. Under no circumstances may you use a bathroom cleaning product formulated to clean bathroom taps to clean Hudson Reed's very special bathroom taps. If the chrome is defective on one of their taps, as is the case for one of mine, they will not remedy the problem if the taps have ever been touched by anything other than water. Apparently their taps are simply not built to withstand the insult of a bathroom cleaning spray. Under no circumstances will their embarrassingly bad customer services department consider that they simply have a defective product, even say if you have bought multiple taps from them and only had a problem with one of them. It is a wonderful get out of jail card they have created for themselves. You kind of have to admire their brass neck, if not their chrome taps.

We bought a HR basin unit through Victoria Plumbing, 1st one has a chunk off on the side , another chunk off the bottom and two of the drawer supports had the screws coming out. The replacement unit has two breaks on the bottom, probably over tighten on assembly and one of the wall hook mechanisms has a bad adjustment screw, it won’t move!!

We are waiting for the 3 replacement unit, hopefully 3rd tome lucky!

Note, the units and draws seem to be really good quality it’s just the built quality is awful.

Ok the 3rd unit just arrived and guess what , it’s damaged at the bottom on two side, they really need to look into who is putting these units together, it seems like they are using a impact driver!!!! Why don’t they check the unit before it leave if it’s a replacement!

Terrible, cheap product. Nut cracked 8 months after installation causing damage to our ceiling and £100s of repair. Purchased through Wayfair. Wouldn't touch this brand ever agian

Have a set of bath taps that have been leaking from under the tap resulted in a full on burst that went under the bath and resulted in the water pipe being cut off from the actual tap base as plumber unable to disconnect taps. How can you actually disconnect the tap with out pulling out the bath

Technical support supplies useless advise for poorly designed Taps! We now left stuck with a shower nut that we can’t remove to change the valve??? Tried adjustable spinner, lime scale remover, WD40 and even had a plumber around that can remove the nut! The Kit is only 3 years old! ANY genius ideas to remove the nut???

23/7/20 - still not resolved by technical team...

I was called out to repair a Hudson Reed Topaz Traditional Three Outlet Push Button Shower Valve which we did not install. Initially we had problems with the water outlet and wanted to undo the brass nut on the check valve filter. This nut seems to be a special size which I couldn’t get and when I requested a socket or spanner from the Company they laughed.
The Technical backup was non existence I personally don’t think they have a clue, they pass you from pillar to post with stupid suggestions which culminated in Deb telling me ‘we do not have or need special tools’ so how can a trademan undo this special nut? It is so easy to put a tool within the packaging of the shower, as other Companies do, because we feel check valves are constant problems.

In conclusion, do not even consider a shower or anything to do with Hudson Reed, stick to well known brands which have served us well for 50 years.

AVOID AT ALL COSTS.❌❌❌‼️‼️🚫

We have the tec lever shower mixer set. The cold tap stopped working (the grooves on the cartridge wore away so that the lever couldn't catch on them) after around 4 years. Despite apparently having a 20 year guarantee, the technical/customer service department are next to useless. Seemed completely uninterested and advised us to buy a replacement cartridge, which ended up being far too big and so didn't fit the tap. They clearly have no technical knowledge about the products they sell. Admittedly the taps look great but they are absolutely not worth the money. Avoid avoid avoid.

I bought a Hudson Reed 3 door mirror bathroom cabinet because it was the right size for the space. I regret this now.
Firstly - design. Weighing in at over 40kg it is too heavy and hangs from only 2 lightweight wall cabinet fittings.
Secondly - packaging. 1st cabinet arrived on a pallet but one of the mirror doors was broken and the end panel fittings had pulled out of the particle board. It looked as it had been dropped. Replacement arrived with a chipped mirror door. The packaging is very flimsy and inadequate for the stresses of shipping. Add in the weight and it becomes a difficult item for delivery.
As it was a day before lockdown I ended up cobbling together a workable cabinet by using an undamaged door from the 1st delivery to mend the 2nd.
Not satisfied

In response to Sean, and Dee McHale we are disappointed here at Hudson Reed that you feel you have had a bad customer experience. I would like to speak with you directly if i could so we can resolve this for you and prevent any further instances. If you call our helpline on 01422417110 and ask them to transfer you to Tony Firminger QA Manager we can discuss.

Kind regards

Tony

Bought a Hudson Reed Grey sink cabinet quality wasn't the best seemed all out of Shape, but they say this is due to transport. 5 months later the coating on the doors are coming apart. Contacted them and sent the photos and guess what it's my fault water ingress. Asked them for the testing information. No answer from them so not sure if the chip board is water resistant. Very poor customer service and quality. They did offer for me to buy more doors but would be charging me. Don't go buy the old saying buy cheap buy twice. Buy expensive and buy twice from hudson reed. You would think that a bathroom item would be water resistant

Hudson Reed Topaz taps
DO NOT WASTE YOUR MONEY
Would have given this product zero stars had it been possible.
They are designed for both crosshead and lever tops so work in opposite ways - fine for levers but extremely annoying for cross head taps as they work in the opposite directions and you end up soaking yourself every time you turn one of them off. The manufacturer's technical assistance is non-existent (they virtually say tough luck but we'll sell you levers) so the only thing you can do is to get replacement valves which work in the correct direction (but manufacturers won't give you the code for the correct type) costing yet more money.
Can't warn you off these enough and only wish I'd read up properly before buying. I'm getting rid of my brand new and expensive taps and won't even sell them on as I wouldn't wish them on anyone else!

We purchased our bathroom fittings from Hudson Reed 15 years ago. We have just developed an issue with shower controls and I phoned up and asked for some help. I spoke to Phil, who couldn't have been more helpful and patient. My issue is now solved, new part ordered and his help was invaluable. 5 Stars all the way for product knowledge and customer service.

Having bought a lot of Hudson Reed products for our last bathroom (toilet, basin, floor standing mixer tap and basin tap) several years ago, we decided to buy virtually all Hudson Reed products when renovating the bathroom in our current house. This was a mistake as their Customer Service and willingness to help with spare parts or technical matters is atrocious.

In summary an area of white gloss flaked off one of the drawers of the basin unit during installation and I simply rang to ask whether a. is it possible to acquire a replacement drawer front or b. is there a white gloss touch up product that HR could recommend to cover the small area.

I was immediately shot down and advised that HR don't do spare parts and don't have any white gloss products. I hadn't even given HR the product code for the unit at this point!!

They refused to take any responsibility as manufacturer, instead repeating that any damage had to be reported within 72 hours of delivery. If it was a manufacturing defect it was not apparent during inspection.

I have since used a white gloss touch up product found myself which covers the area up 'okay'. However after spending hundreds of pounds this time and hundreds of pounds for our last project I will avoid buying any products from HR ever again.

Also the toilet seat buffers for our toilet costing more than £350 just fall out.... Clearly a manufacturing defect.

Parfait le service après vente et à l écoute et réactif

I purchased a WC and Basin Unit from their Apollo range thinking I had bought a quality product. An impression gained from their glossy web site. How wrong can you be!

The WC unit was of only reasonable quality but the Basin Unit was unbelievably poor, in a number of ways.

There was no means of fixing the cupboard to the wall. Wall brackets where provided but the mating adjustable brackets for the cupboard were not. It soon became apparent why, there was nothing to mount them too! In the end I had to add a piece of timber to the open back of it to allow both for screwing it to the wall and to support the basin. As sold there was no support for the rear edge of the basin or any method of attaching it to the cupboard.

Additionally, the back edge of the basin overhung the back edge of the cupboard. This stopped the cupboard from being screwed flush to the wall. To overcome this problem I had to use a router to remove 6mm from the front cross rail to allow the basin to come forward enough to make it flush with the rear of the cupboard. It shouldn’t be necessary to do this, especially when it requires the use of specialist tools. The basin should fit the cupboard!

This all smacks of poor design and poor manufacture leading to abysmal quality.

I have worked in British industry for over 45 years, a large proportion of it in a senior design management role. In all that time I have never come across such poor design and integration with parts not fitting to each other as intended. It’s just incredibly shoddy.

I can also confirm that their customer support is very bad. They accept no responsibility and make lame excuses why parts are not as expected.

Save yourself a lot of bother and money and buy from a reputable suppler.

Weeks trying to deal with the simplest of issues, supplied bracket was too short for the task.
Initially contacted them by telephone early in October to report the connecting bracket for their WRSB250 Wetroom Return Screen was too short. I explained I had two sets of these, one was fine, but for some reason this one was too short. I expected to be provided with a replacement during the telephone call, however, was requested to provide purchase details and photos which I did. The photos show what I had described, however, I was requested to provide addtional photos from a wider angle, which I did. I was then asked to measure the glass screens just in case the bracket wasn't in fact too short, it might be the right size, but perhaps the glass screens were too long and I hadn't noticed. I had informed them I had two identical sets, one of sets of screens already installed perfectly well with the correct length of bracket but they somehow though I was stupid enough that perhaps the screens may be a different heights I had told them over and over and over this bracket was too short. I must confess my final emails were rude, but how many times do you need to tell someone the simplest of things, when you have explained it all over and over already, it was unbelievable, genuinely the worst level of support I have experienced, no exaggeration.
Now they won't deal with me, because I was rude, can't believe the time I have wasted dealing with these people for the simplest of matters, unbelievable. Almost forgot, I spent four thousand pounds on their products for my house renovation.

I thought it was good, but the customer services are extremely poor. The lady were arguing with me, and did not let me speak. She would ask a question, and before I could finish my answer, she had answer my answer. I told her it is design fault, as the head and hand held is at so opposite position, so the shower head had less hot water than than hand held. She blame on handsets, but I removed both headset, etc so there is no blockage to blame. Then she blame the boiler. I said it is megaflo and then she blame the temperature. I said the output temp is 60c. I told her if I swap the head and hand held and if it is hot, then what happen, will you admit there is a design flaw. Of course she did reply to my answer and went off blaming my boiling system etc.
Likewise, why have female connector when the pipeworks are female, waste money to buy connectors.
I will not buy this product again and I hope it last longer than my last one which were 7 years.
She does not listen to customer and predicts what we will say. Will not admit her product has fault. Pointless phoning in for help. Best not to buy this product, stay away.